Магазин радиоуправляемых
моделей и игрушек.
На рынке с 2007 года
График работы: г. Москва, ул. Новоостаповская, 5/1
Пн-Пт - 10.00 - 17.00 6 этаж, офис 208.
Сб-Вс - Выходной м. "Дубровка", "Волгоградский пр."
8 (495) 411-22-91
email: vyacheslavyugay@mail.ru
Introduction
This power combo consists of Skylord 80A ESC and Tomcat TC-G-5030-KV400 (G601) motor. It has the advantages of strong power, precisely controlling, rapid response and etc.
Features
Skylord 80A ESC
- Microprocessor in the ESC is powered by separate voltage regulator IC, with better anti-jamming capability, greatly reducing the possibility of out of control.
- The throttle range can be configured, fully compatible with the available transmitter. The ESCs have smooth and accurate speed control, and excellent throttle linearity.
- The highest motor speed: 210000 RPM (2 poles), 70000 RPM (6 poles), 35000 RPM (12 poles).
- Support three start modes, Normal, Soft and Super-soft. Normal mode is suitable for fixed-wing aircraft. Soft and Super-soft modes are suitable for helicopter.
- The ESC has full protection features such as low voltage protection, over-heat protection, over-load protection, and throttle signal lost protection, it can effectively extend the service life of the ESC.
- Support multiple programmable items which could meet more users' need.
- A 3-in-1 programming card with a very small size and intuitive interface can be purchased additionally for easily programming the ESC. It brings much more convenience for users than transmitter.
Tomcat TC-G-5030-KV400 (G601) motor
- The motor is made of high-strength aluminum alloy casing which can greatly strengthen the impact resistance.
- The winding uses 240℃ heat-resistant magnet wire after the vacuum impregnation treatment, which can improve the heat conduction and heat resistance, prolong the service life of motor.
- Special bearing imported from Japan is wear proof. It still provides smooth high-speed rotation after using for a long time.
- N45H magnet is hard to degauss even in the high temperature and can guarantee the reliable high torque output.
- Optimized design provides high efficiency way for dissipating heat, which gives the capability of consistent high power output.
- Through the handling of dynamic balancing, Tomcat motor can lower the vibration and noise during the motor’s high-speed rotation.
Specifications
Skylord 80A ESC
Model |
Cont. Current |
Burst Current (10s) |
BEC Mode |
BEC Output |
BEC Output Capacity |
Battery Cell |
Weight |
Size (L*W*H, unit: mm) |
||||
2S Li-Po |
3S Li-Po |
4S Li-Po |
5S Li-Po |
Li-Po |
Ni-MH |
|||||||
Skylord-6A |
6A |
8A |
Linear |
5V/1A |
3 servos |
- |
- |
- |
2 |
5~6 |
5.5g |
32*12*4.5 |
Skylord-12A |
12A |
15A |
Linear |
5V/2A |
5 servos |
4 servos |
- |
- |
2~3 |
5~9 |
10g |
38*18*7 |
Skylord-15A |
15A |
20A |
Linear |
5V/2A |
5 servos |
4 servos |
- |
- |
2~3 |
5~9 |
17g |
48*23*6 |
Skylord-20A |
20A |
25A |
Linear |
5V/2A |
5 servos |
4 servos |
- |
- |
2~3 |
5~9 |
20g |
42*25*8 |
Skylord-30A |
30A |
40A |
Linear |
5V/2A |
5 servos |
4 servos |
- |
- |
2~3 |
5~9 |
38g |
65*25*12 |
Skylord-40A-UBEC |
40A |
55A |
Switch |
5V/3A |
5 servos |
5 servos |
5 servos |
- |
2~4 |
5~12 |
42g |
65*25*12 |
Skylord-50A-UBEC-3A |
50A |
65A |
Switch |
5V/3A |
5 servos |
5 servos |
5 servos |
- |
2~4 |
5~12 |
42g |
65*25*12 |
Skylord-50A-UBEC-5A |
50A |
65A |
Switch |
5V/5A |
8 servos |
8 servos |
6 servos |
- |
2~4 |
5~12 |
42g |
65*25*12 |
Skylord-60A-UBEC |
60A |
80A |
Switch |
5V/5A |
8 servos |
8 servos |
6 servos |
6 servos |
2~6 |
5~18 |
62g |
77*35*14 |
Skylord-80A-UBEC |
80A |
100A |
Switch |
5V/5A |
8 servos |
8 servos |
6 servos |
6 servos |
2~6 |
5~18 |
80g |
86*38*12 |
Skylord-100A-UBEC |
100A |
120A |
Switch |
5V/10A |
12 servos |
12 servos |
10 servos |
10 servos |
2~6 |
5~18 |
74g |
70*30*20 |
Tomcat TC-G-5030-KV400 (G601) motor
Type: TC-G-5030-KV400 (G601)
KV(rpms per volt): 400
No load current: 1.65 A @10V
Resistance: 0.034 ohms
Watts: up to 1500
Continuous Current: 55A
Max Burst Current: 65A,10seconds
Cells: 5~7 S Li-Po
Recommended Props: 14x8 to 16x10
Slots,Poles: 12,14
Diameter: 50 mm
Shaft: Diameter 6.0 mm
Weight: 408 g
Brushless ESC: 80A